FAQs
 

FAQs

  • 1. The WiFi extender is not working. What should I do?

    Having an older version of firmware can cause this issue. Steps to follow: Ensure the extender is connected to a live electrical plug and the power connector. Check that the extender is inside the Wi-Fi range of the remote switch and that the customer’s device has been associated to the extender configuration

  • 2. WPS button - what is it?

    Wi-Fi Protected Setup is known as WPS. It is a major standard for remote system security that makes it easier and quicker to connect  remote devices & systems to switches. WPS only functions with remote systems that utilize a secret key scrambled according to the WPA2 Personal and WPA Personal security standards.

  • 3. Can't  connect my WiFi extender?

    An extender  with an out-of-date firmware may encounter this sort of issue. Steps to follow: check if  the extender is connected to the power connector and plug it into a live electrical power outlet. A client gadget should be connected to the extenders and the extender must be inside the scope of the remote switch.

  • 4. My Netgear extender isn't working. What should I do?

    Reboot your fundamental switch and extender to perform a power cycle. Connect your NETGEAR extender to its default WiFi system. Re-run the NETGEAR extender arrangement wizard via the internet browser. Should the problem persist, the extender should be reset back to the default processing  factory settings

  • 5. What are the steps for resetting my WiFi extender?

    On the back board, press the reset button until the Link Rate LED and Device to Extender flicker. About five to ten seconds are required to complete this process. …
    Press the release button.
    Be patient while the extender reboots.
    Use the default password to log in.  Login with username (“admin”) and password (“password”).

  • 6. How can I connect an Ethernet cable to a WiFi extender?

    With an Ethernet link, connect your computer to the extender. Each of the five Ethernet LAN ports on the extender can be used. Note-You should not use an Ethernet link to connect an extender to a Wi-Fi switch. If you happen to do it , the extender will not work, as it is intended to work only  with Wi-Fi connections and Wi-Fi switches.